Sony DVS-9000 User Manual page 161

3
4
5
Setting the start point and stop point with the [SET XX] buttons
When you enter a timecode and make a setting with the [SET START TC],
[SET STOP TC], or [SET DUR] button in the device control block (search
dial), the timecode display changes as follows. With these buttons you can set
the start point and stop point timecodes, and the duration (the duration is not
displayed). When two of these values are set, the remaining one is
automatically determined.
Example 1
1
2
3
160
Control of VTRs, Extended VTRs, and Disk Recorders
Enter the number of the register to be recalled with the numeric keypad
buttons.
Press the [REWIND] button in the keyframe control block.
The VTR/Extended VTR/disk recorder automatically advances to the
timecode value set as the start point.
While the VTR/Extended VTR/disk recorder is operating, the [ALL
STOP] button in the device control block flashes amber, and when the start
point is reached lights green.
If the operating VTR/Extended VTR/disk recorder is selected as the
reference region in the device control block, the [CUE] button also flashes
and lights in the same way as the [ALL STOP] button. Also, when the start
point is reached, the [STOP] button lights amber.
Press the [RUN] button in the keyframe control block.
The VTR/Extended VTR/disk recorder is now controlled according to the
keyframe data.
Press the [SET START TC] button, and enter "00000000" from the
numeric keypad control block.
START TC
STOP TC
(DUR (not displayed)
Press the [SET STOP TC] button, and enter "200" from the numeric
keypad control block. This automatically sets DUR.
START TC
STOP TC
(DUR
Press the [SET DUR] button, and enter "–100" from the numeric keypad
control block.
00:00:00:00
--:--:--:--
)
00:00:00:00
00:00:02:00
0:02:00)