• When Wedge was selected in step 1
Knob
4
5
To set the wedge center position
When Wedge is selected in the <Mode> group, you can set the wedge center
position.
1
Press [Position].
2
Set the following parameters.
Knob
1
2
Split settings
The Split effect splits the image upper and lower, left and right.
To apply the Split effect
With the Split menu displayed, use the following procedure.
1
In the <Mode> group, select the split method.
Single: Leave gaps between splits.
Double: Fill gaps between splits with the same image.
2
Set the following parameters.
Knob
1
2
To set the split position
1
Press [Position].
2
Set the following parameters.
Parameter
Adjustment
No
Width of blocks
Phase
Partition position
Parameter
Adjustment
H
Horizontal center position
V
Vertical center position
Parameter
Adjustment
Transition H
Degree of left and right separation
Transition V
Degree of top and bottom
separation
Setting values
0.000 to 100.000
–8.000 to +8.000
Setting values
–8.000 to +8.000
–6.000 to +6.000
Setting values
0.000 to 100.000
0.000 to 100.000
DME Special Effect Operations
87