Sony DVS-9000 User Manual page 354

Setting the transition rate display mode
To determine whether to display transition rate values in menus and on the
control panel in frames or as timecode values, select either of the following in
the <Trans Rate Display> group.
Frame: display in frames.
Timecode: display as timecode (SS:FF).
Making settings relating to effects
To make settings relating to the functions used when carrying out keyframe
effect operations, use the following procedure.
1
In the Panel >Operation menu, press [Effect Mode].
The Effect Mode menu appears.
The status area shows a list of the items with their settings.
2
Make the following settings as required.
Effect recall mode: To select the state of the first keyframe when an effect
is recalled, select [Recall] (the first keyframe is not recalled) or
[Recall&Rewind] (the first keyframe is recalled) in the <Recall
Mode> group.
Automatically turning [EDIT ENBL] off: When an effect is recalled
with the [EDIT ENBL] button on, to automatically turn this button off,
disabling keyframe editing, turn [Edit Enable Auto Off] on.
Automatic first keyframe insertion: When an empty register is recalled,
to automatically insert a first keyframe of the state at that point, turn
[1st KF Auto Insert] on.
Automatic effect saving: To automatically save an effected when it is
recalled after being edited, turn [Effect Auto Save] on.
Keyframe duration default value: Press [Default KF Duration], then
enter the default value from the numeric keypad window.
Setting the first keyframe when a rewind is executed
For P-Bus, GPI, and DDR/VTR timeline operations, to execute the first
keyframe when a rewind is carried out, set each external device on in the
<REWIND&1st KF> group in the Effect Mode menu.
Note
When an effect is executed by pressing the [RUN] button with this setting on,
the first keyframe action is not executed.
GPI: setting for the GPI timeline
P-Bus: setting for the P-Bus timeline
Setup Relating to Operations From the Control Panel
353