Sony DVS-9000 User Manual page 313

Setting the assignment of macro operation buttons
Note
This setting applies to all simple type Flexi Pad control blocks on the control
panel.
To switch the [UNDO] button on a simple type Flexi Pad control block to a
[MCRO] button for macro operation, use the following procedure.
1
2
Assigning the dual background bus mode switching function
The dual background bus mode is a mode in which the background A row
shifted signal can be selected with the key 1 row, and the background B row
shifted signal can be selected with the key 2 row. To switch this mode on and
off, it is necessary to assign this function to the cross-point control block [PRE
MCRO] button.
For details of the dual background bus, see "Signal Selection" in Chapter 1
(Volume 1).
1
2
3
4
312
Setup Relating to Operations From the Control Panel
In the Panel >Config >Link/Program Button menu, press [Flexi Pad
Module].
The Flexi Pad Module menu appears.
Select the assignment of the [UNDO] button in the simple type Flexi Pad
control block from the <UNDO Button Assign> group.
UNDO: use as an [UNDO] button.
MACRO: use as a [MCRO] button.
In the Panel >Config menu, press [Link/Program Button].
The Link/Program Button menu appears.
Press [Xpt Module].
The Xpt Module menu appears.
Select the bank (M/E-1 to M/E-3 or P/P) in the status area.
In the <PRE MCRO/POST MCRO> group, select [Dual Bkgd Bus].
This assigns the dual background mode to the [PRE MCRO] button, and
disables the [POST MCRO] button.