This returns the assignment of region selection buttons in the numeric keypad
control block to the factory default state.
To delete a region assignment
In step 3 of the procedure "Assigning a region to a region selection button in
the numeric keypad control block" (page 307), make the selection to which the
operation applies, then press [Clear].
This clears the assignment of the selected region.
Setting the assignment of transition type selection buttons
You can change the assignment of transition type selection buttons in the
transition control block.
1
In the Panel >Config menu, press [Link/Program Button].
The Link/Program Button menu appears.
2
Press [Transition Module].
The Transition Module menu appears.
3
Select the bank of the transition control block you want to set in the <Bank
Select> group.
The current assignment of the transition type selection buttons appears at
the upper left.
4
Press the transition type selection button for which you want to change the
assignment.
The button you pressed appears in reverse video.
5
Using any of the following methods, select the transition type to be
assigned, from the list on the right.
• Press directly on the list.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob
1
6
Press [Set].
The texts on the button illustrations change to reflect the selection.
Parameter
Adjustment
Button
Selection of transition type
Assign
Setup Relating to Operations From the Control Panel
Setting values
1 to 10
309