Sony DVS-9000 User Manual page 390

Enabling or disabling AUX bus control
1
In the Switcher >Device Interface menu, press [Aux Control].
The Aux Control menu appears.
2
Select the 9-pin port for the setting, from the <Control> group.
Remote1: Make the settings for the REMOTE1 port.
Remote2: Make the settings for the REMOTE2 port.
Remote3: Make the settings for the REMOTE3 port.
Remote4: Make the settings for the REMOTE4 port.
3
Using any of the following methods, select the AUX bus.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob
1
a) 0: EDIT PVW
1 to 48: AUX1 to AUX48
4
Select whether to enable or disable AUX bus control from the <Control
Mode> group.
Enable: enable control of the port selected in step 2.
Disable: disable control of the port selected in step 2.
Manual: make whether control of the port selected in step 2 is possible or
not depend on the setting in the Misc menu.
5
Repeat steps 2 to 4 as required to make the settings for other ports.
Setting the interface between the DME and the switcher
To set the interface between the DME and the switcher when the DME is an
MVE-8000A or MVE-9000, proceed as follows.
1
In the Switcher >Device Interface menu, press [DME Type Setting].
The DME Type Setting menu appears.
2
In the <DME1 Type> group to set DME1 or in the <DME2 Type> group
to set DME2, press [SDI], turning it on. ([Dedicated] is disabled.)
Dedicated: The MVE-8000A/MVE-9000 has an MVS-8000-series
dedicated interface.
Parameter Adjustment
No AUX bus selection
Setting values
a)
0 to 48
Setup Relating to Switcher Processor
389