Sony DVS-9000 User Manual page 597

Icon Title
Recovery
Complete
Restore
Data
Restore
Data
Set Time/
Date
Warning
Warning
Warning
(System
Config)
596
Error Messages
Message
System disk has been
damaged, and then recovered.
Shutdown and restart the
system is recommended to exit
from recovery mode.
Restoring...
Success!!
Recovery binary on the USB
storage device is not found.
Failure.
Copying recovery data hasn't
finished.
Error: Wrong Format.
No Switcher information
available.
Please confirm "Network
Configuration" on Page 7311.
This operation will be
cancelled, because the register
is locked.
Please change the register
status to be unlocked first.
Illegal Network Config
Information (Page 7311)
Illegal Panel Assign
Information for Dual Simul
Operation (Page 7312)
No Panel Assign Information
(Page 7312)
No Switcher Assign
Information (Page 7312)
No System Operation Mode
Information (Page 7312)
No DME Channel Information
Description
Corruption has been detected in the flash
memory for starting the menu CPU, but this has
been recovered. Since the system is operating
in recovery mode, shut down and restart as
a)
soon as practicable.
Appears while restoring recovery data using
a)
Menu 9999.
Appears when recovery data has been
successfully restored using Menu 9999.
Recovery data for restoring using Menu 9999
cannot be found on the memory card. Check
that the recovery data has been correctly
copied to the memory card, and restart the
a)
system to retry.
Restoring recovery data using Menu 9999
failed. Check that the recovery data has been
correctly copied to the memory card, and
restart the system to retry.
7317: Engineering Setup >System
>Maintenance
In the above menu, an incorrect date and time
was specified. Specify the date and time
correctly.
When starting up the menu system, the
switcher is not present in the system
information. Check the Data LAN connections,
and in the 7311:Engineering Setup >System
>Network Config menu, retry [Auto Config].
6211.1: Effect >Master Timeline >Store >Edit
6311.1: Snapshot >Master Snapshot >Store
>Edit
6411.1: Shotbox >Register >Store>Edit
In the above menus, an attempt was made to
store in a locked register. Unlock the register
before carrying out the store.
When starting up the menu system, if the
system information read from the control panel
is not correct, one of these messages, that
corresponds to the situation appears.
Following the message, use 7311:Engineering
Setup >System >Network Config or
7312:Engineering Setup >System >System
Config to retry the operation.
a)
a)