Sony DVS-9000 User Manual page 351

Test firing the trigger
To test fire the trigger, press [Test Fire].
This outputs a trigger from the selected output port. This is not output when the
trigger type is "Status."
Setting the control mode for P-Bus devices
In the <P-Bus Control> group of the Panel >Device Interface menu, select the
mode.
Trigger: When a predetermined button is pressed, the action command
Timeline: The external device is controlled as a keyframe effect controlled by
Setting the SCU editor panel port
When an editing keyboard is used, this port setting is for the editing keyboard
if the license for the BZS-8050 is valid (see page 283), and for the serial tally
if the license for the BZS-8050 is invalid.
If you want to use the port setting for the serial tally when the license for the
BZS-8050 is valid, select [Serial Tally] from the <Editor Port Assign> group
in the Panel >Device Interface menu.
Serial Tally: Use the SCU editor panel port for the serial tally.
Editor Keyboard: Use the SCU editor panel port for the editing keyboard.
Making DCU serial port settings
You can assign buttons in the device control block (DEV1 to DEV12) to DCU
serial ports, to operate the devices (disk recorder/VTR/Extended VTR)
connected to these ports. For a disk recorder/Extended VTR, you can also set
the sharing of file lists.
For details of DCU serial port settings, see "Serial Port Settings (Serial Port
Assign Menu)" (page 408).
To associate a serial port with a device selection button
1
2
350
Setup Relating to Operations From the Control Panel
assigned to that button is output, to control an external device.
the center control panel.
In the Panel >Device Interface menu, press [DCU Serial Port Assign].
The Serial Port Assign menu appears.
Using any of the following methods, select the DCU serial port.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.