Preparations - Sony DVS-9000 User Manual

Preparations

Note
To use the color corrector, the BZS-9420 Color Corrector Software is required.
To use the software, you need to obtain a further installation key.
For details on obtaining an installation key, see Chapter 16, "Making settings
required to use the software" (page 283).
On a 4M/E system or a 3M/E system with a board with multi-format support,
it is not possible to use an M/E reentry signal in an overlaid manner on the key
bus or utility 1 bus even when not using the color corrector.
Example 1: When M/E-1 is selected on the M/E-2 background A bus (or
Example 2: When M/E-2 is selected on the M/E-3 background A bus (or
Assigning the color corrector input buses to AUX delegation
buttons
There are two inputs for capturing material to the color corrector: the CCR1
bus and the CCR2 bus.
For details of the input assignment operation, see "Auxiliary Bus Control
Block Settings (Aux Assign Menu)" (page 329).
Selecting the color correction input signal
After assigning CCR1 and CCR2 to AUX buses, use the following procedure.
1
2
514

Preparations

background B bus, key bus, utility 1 bus, or utility 2 bus), it is not possible
to select M/E-2 on the M/E-3 key bus or utility 1 bus.
background B bus, key bus, utility 1 bus, or utility 2 bus), it is not possible
to select M/E-3 on the PGM/PST key bus or utility 1 bus.
In the auxiliary bus control block, press the AUX delegation buttons
assigned to CCR1 (or CCR2).
In the cross-point button row, select the signal to which you want to apply
color correction.
Note
The signals you can select on the CCR1 and CCR2 buses are limited to the
primary inputs and frame memory outputs (FM1 to FM8). However you
can make all the internal signals of the switcher selectable by a setting in