Sony DVS-9000 User Manual page 363

Note
When Multi Program mode is selected, two or more transition type indication
may light. It is also possible that more than one "Transition Type" has been
selected in the Misc >Transition menu for each M/E.
To assign the output of each bank in Multi Program mode
When you selected [Multi Program] in the procedure described in "Setting the
operation mode" (page 361), use the following procedure.
1
2
3
To set the output configuration for each bank
When you selected [Multi Program] or [DSK] in the procedure described in
"Setting the operation mode" (page 361), use the following procedure.
1
2
3
4
362
Setup Relating to Switcher Processor
In the Switcher >Config menu, press [M/E Output Assign].
The M/E Output Assign menu appears.
On the list in the status area, select the bank output to be assigned.
The selected output appears in reverse video.
In the <M/E Output Assign> group, select the output signal to be assigned.
In the Switcher >Config menu, press [PGM Config].
The PGM Config menu appears.
The status area shows the background and key configuration assigned to
the output of each bank.
Using either of the following methods, select the output for which you
want to make the setting.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob Parameter Adjustment
1 No (PGM) Output to which setting applies
The selected output appears in reverse video.
In the <Bkgd> group, select the background.
In Multi Program mode, select [Clean] or [Utility2], then skip to step 5.
In DSK mode, select one of [Bkgd1] to [Bkgd4].
In DSK mode, turn the knobs to select the background signal.
Setting values
1 to 16