Sony DVS-9000 User Manual page 358

Operation mode of the [XPT HOLD] buttons in the key rows: Set the
operation mode of the [XPT HOLD] buttons in the key rows in the
<Key Bus Xpt Hold> group, as follows.
Normal: The <Xpt Hold Mode> in the Switcher >Key/Wipe/FM/
CCR menu is enabled.
Protect: In this mode, pressing a panel button cannot change the
cross-point settings.
The button On/Off state is preserved in each of the "Normal" and
"Protect" modes. For example, if the [XPT HOLD] buttons are "On"
in the Normal mode, and you switch to Protect mode, then if the [XPT
HOLD] buttons were "Off" in this mode the previous time, the [XPT
HOLD] buttons go off, and if they were "On" they light.
[UTIL] button operation mode: To set the operation mode of the [UTIL]
button in the cross-point control block, press either of the following in
the <Util Button> group.
Hold: Acts as a utility button while held down, changing the
assignment of the cross-point button rows.
Lock: For the key rows, each time the button is pressed the cross-point
button assignment toggles between the utility assignment and the
normal assignment. The background A and B rows are fixedly
assigned to the A and B rows, even if the [UTIL] button is pressed.
(For details, see "Names and Functions of Parts of the Control
Panel" in Chapter 2 (Volume 1).)
Setting trackball, joystick, search dial, and double-click
sensitivity
You can set the operational sensitivity for trackball, joystick and the buttons
which recall the relevant menus when pressed twice, and the relation of the
rotation angle of search dial with the playback speed.
1
In the Panel >Operation menu, press the [Sensitivity].
The Sensitivity menu appears.
The status area shows a list of the items with their settings.
2
Make the following settings as required.
Trackball and Z-ring sensitivity in normal mode: In the <Trackball
Normal Mode> group, select [×1], [×2], or [×4].
Trackball and Z-ring sensitivity in fine mode: In the <Trackball Fine
Mode> group, select [
Note
1 1 1
/ ], [ / ], or [ / ].
2 4 8
Setup Relating to Operations From the Control Panel
357