Sony DVS-9000 User Manual page 149

4
5
Repeat steps 1 to 5 for other GPI output ports as required.
Testing trigger output
To test the trigger output, press [Test Fire].
According to the list settings on the left of the status area, a pulse is output from
the selected output port.
148
Control of GPI Devices
Knob Parameter
2 GPI Port No
a) 1: Off (no specification)
2: Control panel (SCU) GPI port
3: DCU GPI port
If in step 3 you selected 2 (SCU) or 3 (DCU), then use the knob to select
the port number.
The indication for knob 3 depends on whether SCU or DCU is selected.
Knob Parameter
3 SCU Port No
3 DCU Port No
a) The number of DCU GPI ports depends on the settings in Engineering Setup.
The setting is reflected in the list on the right of the status area.
Note
For the output port you have set here, be sure to set the trigger type to
"Rising Edge," "Falling Edge" or "Any Edge."
For details of the trigger type settings, see "Making control panel GPI
output settings" (page 348) and "Making DCU GPI output settings" (page
406).
Press [Set].
This specifies the SCU/DCU GPI port whose number you specified in step
4 as the pulse output destination for the GPI output port selected in the list
on the left of the status area.
Setting
SCU/DCU GPI port to be the
trigger output destination
Setting
SCU GPI port number
DCU GPI port number
Setting values
a)
1 to 3
Setting values
1 to 8
a)
1 to 50