Sony DVS-9000 User Manual page 423

3
4
Changing the wiring settings
1
2
3
422
Setup Relating to Router Interface and Tally
Destination From: Specify the start destination address for the wiring
configuration.
Destination To: When the wiring configuration is multiple, specify the
end destination address. For a single wiring connection, this setting is
not required.
Destination Level: Specify the destination level of the wiring
configuration.
Knob Parameter
1 Destination (From)
2 Destination (To)
3 Destination (Level)
Set the source.
Source From: Specify the source start address for the wiring
configuration.
Source Level: Specify the source level for the wiring configuration.
Knob Parameter
4 Source (From)
5 Source (Level)
Press [Execute].
This makes the wiring setting according to the specifications in steps 2 and
3.
In the Router/Tally >Wiring menu, press [Modify].
The Modify menu appears.
Referring to steps 2 and 3 in the preceding section "Making new wiring
settings," change the parameters as required. In this case, however, it is not
possible to specify multiple destinations in a single operation, and a single
"Destination Address" must be specified.
Press [Execute].
This updates the wiring settings.
Adjustment
Destination start address 1 to 1024
Destination end address
Destination level
Adjustment
Source start address
Source level
Setting values
From start address to
1024
1 to 8
Setting values
1 to 1024
1 to 8