Setting the border color
The operation differs depending on the DME used (MVE-8000A or BKDS-
9470/MVE-9000).
When the MVE-8000A is used
Press [Border Color], turning it on, and set the following parameters.
Knob
1
2
3
When the BKDS-9470 or MVE-9000 is used
Use the buttons in the <Border Fill> group to select the signal to insert in the
border.
Flat Color: single color
Mix Color: mix color signal set in the Color Mix menu (see page 50)
Ext Video: an external video signal input to the Ext IN connector
If Flat Color is selected, adjust the following parameters.
Knob
1
2
3
26
DME Special Effect Operations
Knob
Parameter
Adjustment
2
V
Border width on top and bottom
sides
3
All
Border width on all sides
5
Density
Border density
Knob
Parameter
Adjustment
1
Top
Border width on top side
2
Left
Border width on left side
3
Right
Border width on right side
4
Bottom
Border width on bottom side
5
Density
Border density
Parameter
Adjustment
Luminance
Luminance
Saturation
Saturation
Hue
Hue
Parameter
Adjustment
Luminance
Luminance
Saturation
Saturation
Hue
Hue
Parameter group [1/2]
Parameter group [2/2]
Setting values
Top value shown
Left value shown
0.00 to 100.00
Setting values
–4.50 to +4.50
–8.00 to +8.00
–8.00 to +8.00
–4.50 to +4.50
0.00 to 100.00
Setting values
0.00 to 100.00
0.00 to 100.00
359.99 to 0.00
Setting values
0.00 to 100.00
0.00 to 100.00
359.99 to 0.00