Mitsubishi Electric 800 Series Instruction Manual page 148

 Valid/invalid status of monitor outputs during the test run
: Valid
: Invalid (always displays 0)
∆: Displays accumulated value before the test
―: Not monitored
Types of monitor
Output frequency
Fault display
Frequency setting value
Running speed
Converter output voltage
Electric thermal relay load factor
Output current peak value
Converter output voltage peak
value
Load meter
Cumulative energization time
Reference voltage output
Actual operation time
Cumulative power
Trace status
Station number (RS-485
terminals)
Station number (PU connector)
Station number (CC-Link)
Energy saving effect
Cumulative energy saving
PID set point
PID measured value
*1 Different output interface (operation panel, parameter unit, terminal CA or terminal AM) can output different monitored items. For details, refer to
page 284.
*2 When the operation is switched to the test run, "0" is displayed. When PM motor control is selected again after a test run, the output current peak
value and the electronic thermal relay load factor from the last operation are displayed.
*3 The monitored status can be output via the terminal AM only.
*4 When the operation is switched to the test run, accumulated thermal value is reduced by considering the output current is "0".
Parameters referred to
Pr.52 Operation panel main monitor
Pr.158 AM terminal function
DU/PU AM/CA
Monitor Output
display
 

―
 
 
 
*2 *2


*2 *2
 
 
 

―
― 

―
∆ ―
 

―

―
 ―
 
∆ ―
 
 
selectionpage 274
selectionpage 284
Types of monitor
PID deviation
Input terminal status
Output terminal status
Option input terminal status
Option output terminal status
Motor thermal load factor
Inverter thermal load factor
PTC thermistor value
PID measured value 2
PID input pressure value
Remote output 1
Remote output 2
Remote output 3
Remote output 4
PID manipulated amount
Second PID set point
Second PID measured value
Second PID deviation
Second PID measured value 2
Second PID manipulated amount 
DU/PU AM/CA
Monitor Output
display

*3


―
 ―

―

―
*4 *4
 
*4 *4
 

―
 
 
 
 
 
 

*3

 
 

*3

 
*3

5. PARAMETERS
5.2 Control method
3
4
5
5
5
6
7
8
9
10
147