Mitsubishi Electric 800 Series Instruction Manual page 6

WARNING
Usage
 Stay away from the equipment after using the retry function in this product as the equipment will
restart suddenly after the output shutoff of this product.
 Since pressing the STOP/RESET key may not stop output depending on the function setting status,
separate circuit and switch that make an emergency stop (power OFF, mechanical brake operation for
emergency stop, etc.) must be provided.
 OFF status of the start signal must be confirmed before resetting the inverter fault. Resetting inverter
fault with the start signal ON restarts the motor suddenly.
 Do not use a PM motor for an application where the PM motor is driven by its load and runs at a speed
higher than the maximum motor speed.
 Use this inverter only with three-phase induction motors or with a PM motor. Connection of any other
electrical equipment to the inverter output may damage the equipment.
 Do not modify the equipment.
 Do not perform parts removal which is not instructed in this manual. Doing so may lead to fault or
damage of the product.
5