Mitsubishi Electric 800 Series Instruction Manual page 176

 GOT initial setting (PU connector) (Pr.999 = "10, 12")
Pr.
79 Operation mode selection
118 PU communication speed
119 PU communication stop bit length
120 PU communication parity check
121 Number of PU communication retries
122 PU communication check time interval
123 PU communication waiting time setting
124 PU communication CR/LF selection
340 Communication startup mode selection
414 PLC function operation selection
*1 The setting is changed when Pr.414 = "0" (initial setting).
 Initial setting with the GOT2000 series
• When "FREQROL 500/700/800, SENSORLESS SERVO" is selected for "Controller Type" in the GOT setting, set Pr.999
= "10" to configure the GOT initial setting.
• When "FREQROL 800 (Automatic Negotiation)" is selected for "Controller Type" in the GOT setting, the GOT automatic
connection can be used. When "FREQROL 800 (Automatic Negotiation)" is selected for "Controller Type" in the GOT
setting and the GOT automatic connection is not used, set Pr.999 = "12" to configure the GOT initial setting. (Refer to
533)
 Initial setting with the GOT1000 series
• Set Pr.999 = "10" to configure the GOT initial setting.
NOTE
• Always perform an inverter reset after the initial setting.
• For details on connection with GOT, refer to the Instruction Manual of GOT.
 GOT initial setting (RS-485 terminals) (Pr.999 = "11, 13")
Pr.
79 Operation mode selection
332 RS-485 communication speed
333 RS-485 communication stop bit length
334 RS-485 communication parity check selection
335 RS-485 communication retry count
336 RS-485 communication check time interval
337 RS-485 communication waiting time setting
340 Communication startup mode selection
341 RS-485 communication CR/LF selection
414 PLC function operation selection
549 Protocol selection
*1 The setting is changed when Pr.414 = "0" (initial setting).
 Initial setting with the GOT2000 series
• When "FREQROL 500/700/800, SENSORLESS SERVO" is selected for "Controller Type" in the GOT setting, set Pr.999
= "11" to configure the GOT initial setting.
• When "FREQROL 800 (Automatic Negotiation)" is selected for "Controller Type" in the GOT setting, the GOT automatic
connection can be used. When "FREQROL 800 (Automatic Negotiation)" is selected for "Controller Type" in the GOT
setting and the GOT automatic connection is not used, set Pr.999 = "13" to configure the GOT initial setting. (Refer to
533)
Name Initial value
0
192
1
2
1
9999
9999
1
0
0
Name
Pr.999="10" Pr.999="12"
1 1
192 1152
10 0
1 1
9999 9999
9999 9999
0 ms 0 ms
1 1
0 0
— *1
2
Initial Pr.999="11" Pr.999="13"
value
0 0 0
96 192 1152
1 10 0
2 1 1
1 9999 9999
0 s 9999 9999
9999 0 ms 0 ms
0 1 1
1 1 1
0 — *1
2
0 0 0
5.4 (E) Environment setting parameters
3
Refer to page
204
483
4
5
213
5
463
5
6
page
7
8
9
10
Refer to page
204
483
213
483
463
500
page
175
5. PARAMETERS