Mitsubishi Electric 800 Series Instruction Manual page 466

Hide thumbs Also See for 800 Series:

Table of Contents

 Copying the PLC function project data to USB memory

• This function copies the PLC function project data to a USB memory device. The PLC function project data copied in the

USB memory device can be copied to other inverters. This function is useful in backing up the parameter setting and for

allowing multiple inverters to operate by the same sequence programs.

for an outline of the USB communication function.

• The following data can be copied by copying the project data via USB memory device.

• If the project data of the PLC function is locked with a password using FR Configurator2, copying to the USB memory

device and verification are disabled. Also if set to write-disabled, writing to the inverter is disabled. (For details on the PLC

function, refer to the PLC Function Programming Manual and the Instruction Manual of FR Configurator2.)

Parameters referred to

Pr.338 Communication operation command source

Parameter file

Program file

Function block source information

Global text comment information

Project management information

Copy information

Copy from inverter to USB

memory device

Copy from USB memory

device to inverter

Not available

5. PARAMETERS

5.11 (A) Application parameters

Chapters

Table of Contents