Dell PowerConnect 3324 User Manual page 112

The Port Default VLAN ID (PVID) is configured on the VLAN Port Settings page. All untagged packets arriving to the device are tagged by the ports PVID. To
open the VLAN Port Settings page:
Click Switch > VLAN > Port Settings in the Tree View. The VLAN Port Settings page opens.
l
VLAN Port Settings Page
The VLAN Port Settings page contains the following fields:
Port—Indicates the port number included in the VLAN.
l
Port VLAN Mode—Designates the port VLAN mode.The possible field values are:
l
General—Indicates that the port belongs to one or more VLANs, and each VLAN is user-defined as tagged or untagged (full 802.1Q mode).
¡
Ingress filtering can be disabled only in general-mode ports.
Access—Indicates that the port belongs to a single untagged VLAN. Defining the port VLAN mode as access implies that the ports accept all
¡
untagged frames, and all frames tagged with the VID currently set as the port's PVID. Access mode ports are intended to connect end-stations to
the system, especially when the end-stations are incapable of generating VLAN tags. Ingress filtering is enabled.
Trunk—Indicates that the port belongs to a VLAN in which all frames are tagged. Ingress filtering is enabled on trunk-mode ports.
¡
PVID (1-4095)—Assigns a VLAN ID to untagged packets. This is only implemented for general mode ports. The possible field value range is 1-4095.
l
NOTE: VLAN 4095 is the discard VLAN.
Frame Type—Indicates the packet type accepted on the port. The possible field values are:
l
Admit Tag Only—Indicates that only tagged packets are accepted on the port.
¡
Admit All—Indicates that both tagged and untagged packets are accepted on the port.
¡
Ingress Filtering—Enables Ingress filtering on the port. Ingress filtering discards packets that are associated with a VLAN that does not include the
l
ingress port. The possible field values are:
Enable—Enables ingress filtering on the port.
¡
Disable—Disable ingress filtering on the port.
¡