Table of Contents
Advertisement
Interface—Indicates the selected interface type on which locked port is enabled.
l
Port—Indicates the selected interface type is a port.
¡
LAG—Indicates the selected interface type is a stack member.
¡
Current Port Status—Indicates the current port status.
l
Set Port—Indicates that the port is either locked or unlocked. The possible field values are:
l
Unlocked—Unlocks Port. This is the default value.
¡
Locked—Locks Port.
¡
Action on Violation—Indicates the action to be applied to packets arriving on a locked port. The possible field values are:
l
Forward—Forwards the packets from an unknown source; however, the MAC address is not learned.
¡
Discard—Discards the packets from any unlearned source. This is the default value.
¡
Shutdown—Discards the packet from any unlearned source and locks the port. Ports remain locked until activated or the device is reset.
¡
Trap—Enables sending a trap. The possible field values are:
l
Enable—Enables traps being sent when a packet is received on a locked port.
¡
Disable—Disables traps being sent when a packet is received on a locked port. This is the default value.
¡
Trap Frequency (1-1000000)—Indicates the amount of time (in seconds) between traps. This field only applies to locked ports. The default value is
l
10 seconds.
Defining a Locked Port:
1. Open the Port Security page.
2. Select an interface type and number.
3. Define the Set Port, Action on Violation, and Trap fields.
4. Click Apply Changes. The locked port is added to the Port Security Table, and the device is updated.
Displaying the Locked Port Table:
1. Open the Port Security page.
2. Click Show All. The Port Security Table page opens. The fields in the Port Security Table are the same as the fields in the Port Security page. Locked
Ports can also be defined from the Locked Ports Table as well as the Port Security page.
Port Security Table Page
In addition to the fields displayed in the
Unit No.—Indicates the unit number for which the port security information is displayed.
l
Configuring Locked Port Security with CLI Commands
The following table summarizes the equivalent CLI commands for configuring Locked Port security as displayed in the
Port Security
Page, the Port Security Table page contains the following additional field:
Port Security
Page.
Advertisement
Table of Contents
