Add Source Port
3. Define the Source Port and Type fields.
4. Click Apply Changes. The new source port is defined, and the device is updated.
Deleting a copy port from a port mirroring session:
1. Open the Port Mirroring page.
2. Check the Remove check box.
3. Click Apply Changes. The port mirroring session is deleted, and the device is updated.
Configuring a Port Mirroring Session Using CLI Commands
The following table summarizes the equivalent CLI commands for configuring a Port Mirroring session as displayed in the Port Mirroring page.
CLI Command
port monitor src-interface [rx | tx] Displays the port copy status.
show ports monitor
The following is an example of the CLI commands:
Console(config)# interface ethernet 1/e1
Console(config-if)# port monitor 1/e8
Console# show ports monitor
Source port Destination Port Type Status
----------- ---------------- ----- -------
1/e1 1/e8 RX, TX Active
1/e2 1/e8 RX Active
Configuring Address Tables
Description
Starts a port monitoring session.