Table of Contents
Advertisement
Assigning port settings:
NOTE:
Ingress filtering can only be disabled on ports set to general VLAN mode.
1. Open the VLAN Port Settings page.
2. Define the Port Mode, PVID, Frame Type, and the Ingress Filtering fields.
3. Click Apply Changes. The VLAN port parameters are defined, and the device is updated.
Displaying the VLAN Port Table:
1. Open the VLAN Port Settings page.
2. Click Show All. The VLAN Port Table opens.
VLAN Port Table
In addition to the VLAN Port Settings page fields, the VLAN Port Table page also displays the following field:
Unit—Indicates the stacking unit number for which the VLAN port information is displayed.
l
Assigning Ports to VLAN Groups Using CLI Commands
The following table summarizes the equivalent CLI commands for assigning ports to VLAN groups as displayed in the VLAN Port Settings page.
CLI Command
interface ethernet interface
switchport mode {access | trunk | general}
switchport general pvid vlan-id
switchport general allowed vlan add vlan-list [tagged | untagged]
switchport general allowed vlan remove vlan-list
switchport general ingress-filtering disable
The following is an example of the CLI commands:
Description
Enters the interface configuration mode to configure an ethernet type interface.
Configures a port VLAN membership mode.
Configure the Port VLAN ID (PVID) when the interface is in general mode.
Adds VLANs to a general port.
Removes VLANs from a general port.
Disables port ingress filtering.
Advertisement
Table of Contents
