LACP Parameters Table
In addition to the LACP Parameters page fields, the LACP Parameters Table page also displays the following field:
Unit—Indicates the stacking unit number for which the LACP information is displayed.
l
Configuring LACP Parameters Using CLI Commands
The following table summarizes the equivalent CLI commands for configuring LACP parameters as displayed in the Link Aggregation page.
CLI Command
lacp system-priority value
lacp port-priority value
lacp timeout {long | short}
show lacp ethernet interface [parameters | statistics | protocol-state] Displays LACP information for ethernet ports.
show lacp port-channel
[port_channel_number]
The following is an example of the CLI commands:
Console (config)# lacp system-priority 120
Console (config)# interface ethernet 1/e8
Console (config-if)# lacp port-priority 247
Console (config-if)# lacp timeout long
Console (config-if)# exit
Console# show lacp ethernet 1/e1 statistics
Port 1/e1 LACP Statistics:
LACP PDUs sent:2
Description
Configures the system priority.
Configures the priority value for physical ports.
Assigns an administrative LACP timeout.
Displays LACP information for a Port-channel.