Add Static MAC Address Page
3. Define the Interface, MAC Address, VLAN ID or VLAN Name, and the Status fields.
4. Click Apply Changes. The new static address is added to the Static Address table, and the device is updated.
Modifying a static address in the Static Address Table:
1. Open the Static Address Table.
2. Modify the Port, MAC Address, and the VLAN field.
3. Click Apply Changes. The static address is modified, and the device is updated.
Displaying the Static MAC Address Table:
1. Open the Static Address Table.
2. Click Show All. The Static MAC Address Table opens.
Static MAC Address Table
Removing a static address from the Static Address Table:
1. Open the Static Address Table.
2. Click Show All to open the Static MAC Address Table.
3. Select a single or multiple table entries.
4. Check the Remove check box.
5. Click Apply Changes. The selected static addresses are deleted, and the device is updated.
Configuring Static Address Parameters Using CLI Commands
The following table summarizes the equivalent CLI commands for configuring static address parameters as displayed in the Add Static MAC Address page.
CLI Command
bridge address mac-address {ethernet interface | port-channel port-channel-number}
[permanent | delete-on-reset | delete-on-timeout| secure]
Description
Adds a static MAC-layer station source address to the
bridge table.