Dell PowerConnect 3324 User Manual page 75

console(config-if)# no mdix
The following message displays:
console # show inter config ethernet 1/e1
Flow Admin Back Mdix
Port Type Duplex Speed Neg Control State Pressure Mode
.......................................................
1/e1 100M-Copper Enabled Off Up Disabled Off
The following table summarizes the equivalent CLI commands for configuring ports as displayed in the Port Configuration.
CLI Command
interface ethernet interface
description string
shutdown
set interface active {ethernet interface | port-channel port-
channel-number}
speed {10 | 100 | 1000}
duplex {half | full}
negotiation
back-pressure
flowcontrol {auto | on | off | rx | tx}
mdix {on | auto}
show interfaces configuration [ethernet interface | port-channel
port-channel-number]
show interfaces status [ethernet interface | port-channel port-
channel-number]
show interfaces description [ethernet interface | port-channel port-
channel-number]
The following is an example of the CLI commands:
Console (config)# interface ethernet 1/e5
Console (config-if)#
Console (config-if)# description RD SW#3
Console (config-if)# shutdown
Console (config-if)# no shutdown
Console (config-if)# speed 100
Description
Enters the interface configuration mode to configure an ethernet type interface.
Adds a description to an interface configuration.
Disables interfaces that are part of the currently set context.
Reactivates an interface that is shut down due to security reasons.
Configures the speed of a given ethernet interface when not using auto
negotiation.
Configures the full/half duplex operation of a given ethernet interface when not
using auto negotiation.
Enables auto negotiation operation for the speed and duplex parameters of a
given interface.
Enables Back Pressure on a given interface.
Configures the Flow Control on a given interface.
Enables automatic crossover on a given interface or Port-channel.
Displays the configuration for all configured interfaces.
Displays the status for all configured interfaces.
Displays the description for all configured interfaces.