Table of Contents
Advertisement
GARP Timers Page
The GARP Timers page contains the following fields:
Interface—Indicates the type of interface on which GARP Timers are shown. The possible field values are:
l
Port—Indicates the port for which GARP Timers are displayed.
¡
LAG—Indicates the LAG for which GARP Timers are displayed.
¡
GARP Join Timer (10–2147483647)—Indicates the time in milliseconds that PDUs are transmitted.
l
GARP Leave Timer (10–2147483647)—Indicates the time lapse in milliseconds that the device waits before leaving its GARP state. The Leave Time
l
is activated by a Leave All Time message sent/received, and cancelled by the Join message received. The default is 600 milliseconds.
GARP Leave All Timer (10–2147483647)—Used to confirm the port within the VLAN. The time in milliseconds between messages sent. The default is
l
10000 milliseconds.
NOTE:
The following relationships between the various timer values must be maintained: Leave time must be greater than or equal to three times the
join time. Leave-all time must be greater than the leave time.
Defining GARP Timers:
1. Open the GARP Timers page.
2. Define the Interface, GARP Join Time, GARP Leave Timer, and GARP Leave All Timer.
3. Click Apply Changes. The GARP parameters are saved to the device.
Displaying the GARP Timers Table:
1. Open the GARP Timers page.
2. Click Show All. The GARP Timers Table opens.
Advertisement
Table of Contents
