Table of Contents
Advertisement
console (config)# exit
5. Define an IP address on the device by assigning an IP address to the interface connected to the management station (in this example 50.1.1.1). If the
management station is connected directly to the interface, the IP address on the interface must have the same subnet as the management station.
console> enable
console# configure
console(config)#
console(config-if)# ip address 50.1.1.2 /8
01-Jan-2000 01:48:37 %LINK-W-Down: Vlan 1
console(config-if)# exit
console(config)# exit
6. If the management station is not directly connected to the interface, that is a member of a remote network, define a default gateway on the device.
The gateway configured IP address is the router interface IP connected to the device.
console> enable
console# configure
console(config-if)#
console(config-if)# exit
console(config)# ip default-gateway 50.1.1.100
console(config)# exit
7. Ping the management station from device to make sure that connectivity has been achieved (wait 30 seconds for port to be in STP forwarding before
doing this). Management station IP is (in this example) 50.1.1.3:
console> enable
console# configure
console(config)#
console(config)# exit
console# ping 50.1.1.2
Advertisement
Table of Contents
