Table of Contents
Advertisement
Modifying Port Parameters:
1. Open the Port Configuration page.
2. Select a port in the Port field.
3. Modify the Description, Admin Status, Admin Speed, Admin Duplex, Auto Negotiation, Back Pressure, Admin Auto MDIX and/or Admin Flow Control
fields.
4. Click Apply Changes. The port parameters are saved to the device.
Displaying the Port Configuration Table:
1. Open the Port Configuration page.
2. Click Show All. The Port Configuration Table opens.
Ports Configuration Table
In addition to the Port Configuration page fields, the Port Configuration Table also displays the following field:
Unit Number—Indicates the stacking unit number for which the port information is displayed.
l
Configuring Ports with CLI Commands
The following examples describe how to set a port to MDIX or MDI mode. To set a port to MDIX mode, enter the following at the system prompt:
console(config-if)# mdix on
The following message displays:
console # show inter config ethernet 1/e1
Flow Admin Back Mdix
Port Type Duplex Speed Neg Control State Pressure Mode
.......................................................
1/e1 100M-Copper Enabled Off Up Disabled On
To set a port to MDI mode, enter the following at the system prompt:
console(config)# inter eth 1/e1
Advertisement
Table of Contents
