console> enable
console# configure
Console (config)# interface ethernet 1/e5
Console (config-if)# flowcontrol on
The following is an example for enabling back pressure on port 1/e5 using CLI commands:
console> enable
console# configure
Console (config)# interface ethernet 1/e5
Console (config-if)# back-pressure
Baud Rate
The baud rates can be manually changed to any of the following values:
2400
l
4800
l
9600
l
19,200
l
38,400
l
57,600
l
115,200
l
NOTE:
The default baud rate is 9600.
NOTE:
Closing the device does not return the default baud rate. It must be specifically configured.
NOTE:
In order to enter configuration mode, you must specify administrative level 15 privileges.
The following is an example configuration for changing the default baud rate using CLI commands:
console> enable
console# configure
console(config)# line console
console(config-line)# speed 9600