NEC Electra Elite IPK II Features And Specifications Manual page 155

Electra Elite IPK II
11-16-02 One-Digit Service Code Setup - Barge-In
Use this option to set up Item 02 for single digit Barge-In. For example, you can assign Item 02
to use digit 5 for Barge-In. This would allow you to program a function key with an extension
number plus the Barge-In code (i.e., 305 5). This allows one-touch access to the Barge-In
feature for extension 305. If you un-define a service code, be careful when you change this item
that you don't inadvertently disable any essential dialing function (such as Voice Mail or
Message Waiting).
15-07-01 Programming Function Keys
Assign a function key for Barge-In (code 34).
20-06-01 Class of Service for Extensions
Assign a Class of Service (1-15) to an extension.
20-13-10 Class of Service Options (Supplementary Service) - Barge-In Mode
In an extension's Class of Service, enable the Barge-In Speech Mode (0) or Monitor Mode (1) at
the initiating extension (i.e., Barge-In initiator).
20-13-15 Class of Service Options (Supplementary Service) - Barge-In, Initiate
In an extension's Class of Service, enable (1) or disable (0) Barge-In at the initiating extension
(i.e., Barge-In initiator).
20-13-16 Class of Service Options (Supplementary Service) - Barge-In, Receive
In an extension's Class of Service, enable (1) or disable (0) Barge-In at the receiving extension
(i.e., Barge-In receive).
20-13-17 Class of Service Options (Supplementary Service) - Barge-In Tone/Display
Enable (1) or disable (0) the Barge-In Tone. If disabled, this also turns off the Barge-In display at
the called extension.
20-13-32 Class of Service Options (Supplementary Service) - Multiple Barge-In
Enable (1) or disable (0) the extension's ability to have multiple user's Barge-In to their
conversation.
20-14-11 Class of Service Options for DISA/E&M - DISA/Tie Trunk Barge-In
Use this option to enabled (1) or disable (0) a DISA or tie trunk user from using the Barge-In
feature with the service code un-defined in Program 11-12-08.
20-18-07 Service Tone Timer - Intrusion Tone Repeat Time
After a user Barges In, the system repeats the Barge-In tone after this interval. Normally, you
should disable this timer by entering 0. (This timer also affect any other types of call interruption
features, such as Voice Mail Conversation Recording, Voice Over, etc.)
21-01-03 System Options for Outgoing Calls - Trunk Interdigit Time (External)
Program how long an extension must wait before using the Barge-In feature can be used on a
call (this timer waits until this timer expires before putting a call in a talk state). This timer also
affects Voice Over.
Call Monitoring
Document Revision 1
2 - 133