NEC Electra Elite IPK II Features And Specifications Manual page 388
Hide thumbs
Also See for Electra Elite IPK II:
- User manual (1190 pages) ,
- System hardware manual (642 pages) ,
- Programming manual (617 pages)
Table of Contents
Advertisement
Document Revision 1
To Hold a call in progress at the Base Unit:
1.
Press Hold and return the Handset to the Base Unit.
2.
To return to the held party press the flashing green line key and press Talk or pick up the Handset.
After a programmed time, the held call recalls to the originating terminal.
To Hold a call in progress at the handset:
1.
Press Trf.
2.
An Internal Dial tone is generated.
3.
To return to the held party press the flashing green line key or conference key.
After a programmed time the held call recalls to the originating terminal.
To establish a conference call at the Base Unit:
1.
With a call in progress, press Conf on the Base Unit.
2.
Dial another station number.
3.
Announce Conference (Optional).
4.
Press Conf on the Base Unit to establish the conference.
To Install the battery:
1.
Slide the battery compartment cover on the lower Handset back down to remove it.
2.
Remove the IMPORTANT charging NOTE from the battery compartment.
3.
Align the guides on the bottom of the battery plug and insert it in the connector.
4.
Put the battery in the compartment with the description visible.
5.
Replace and push up the cover to snap it in place.
Ensure that the wires are inside the cover.
To install the belt clip:
1.
Position clip to the back side of the Handset unit with the clip spring pointed up.
2.
Align the four prongs of the clip to the four slots on the sides of the Handset.
Gently press belt clip to snap the prongs into place.
2 - 366
Electra Elite IPK II
term
D
Handset Cordless
Advertisement
Table of Contents
