NEC Electra Elite IPK II Features And Specifications Manual page 93

Electra Elite IPK II
44-01-01 System Options for ARS/F-Route
Select whether the ARS/F-Route feature should use the time schedule (0=not used, 1=used). If
this option is set to '0', the F-Route table selected is determined only by the digits dialed without
any relation to the day or time of the call. If this option is set to '1', the system first refers to
Program 44-10. If there is a match, the pattern defined in that program is used. If not, the F-
Route pattern in Program 44-09 and time setting in 44-08 are used.
44-02-01 Dial Analysis Table for ARS/F-Route Access - Dial
Set the Dial digits for the Pre-Transaction Table for selecting ARS/F-Route (8 digits max: 1~9, 0
#, @). To enter a wild card/don't care digit, press Line Key 1 to enter an @ symbol.
,
44-02-02 Dial Analysis Table for ARS/F-Route Access - Service Type
Set the Service Type (0-3) for the Pre-Transaction Table for selecting ARS/F-Route.
0 = No Setting
1 = Extension Call
2 = ARS/F-Route Table
3 = Dial Extension Analyze Table
44-02-03 Dial Analysis Table for ARS/F-Route Access - Additional Data
If a Service Type is selected in Program 44-02-02, set the additional data, if required, for the
Pre-Transaction Table for selecting ARS/F-Route (24 digits max: 1~9, 0
card/don't care digit, press Line Key 1 to enter an @ symbol.
44-02-04 Dial Analysis Table for ARS/F-Route Access - Dial Tone Simulation
Determine if the Dial Tone Simulation is on (1) or off (0) for the Pre-Transaction Table for
selecting ARS/F-Route. If enabled, this option sends dial tone to the calling party once the
routing is determined. This may be required if the central office at the destination does not send
dial tone.
44-03-01 Dial Analysis Extension Table - Dial
Set the Dial digits (24 digits max: 1~9, 0
Table. When Program 44-02-02 is set to type "3", this program sets the dial extension analysis
table. These tables are used when the analyzed digits must be more than 8 digits. To enter a
wild card/don't care digit, press Line Key 1 to enter an @ symbol.
44-03-02 Dial Analysis Extension Table - Table Number
When dialed digits match the setting in Program 44-03-01, select the ARS/R-Route table
number (0~500) to be used for the Dial Extension Analysis Table.
44-03-03 Dial Analysis Extension Table - Table Number (251)
If the received digits are not identified in tables 1~250, the F-Route selection table number
(0~500) defined in table 251 is used.
44-03-04 Dial Analysis Extension Table - Next Table Number
If the received digits do not match the digits set in tables 1~250, table number 252 is used refer
to the next Extension Table Area (1~4) to be searched.
Automatic Route Selection
#, @) to be used for the Dial Extension Analysis
,
Document Revision 1
#, @). To enter a wild
,
2 - 71