NEC Electra Elite IPK II Features And Specifications Manual page 173

Electra Elite IPK II
14-01-20 Basic Trunk Data Setup - Block Outgoing Caller ID
Allow (1) or prevent (0) the system from automatically blocking outgoing Caller ID information
when a user places a call. If allowed (i.e., block enabled), the system automatically inserts the
Caller ID block code
requires Program 14-02-10 to be enabled). If prevented (i.e., block disabled), the system
outdials the call just as it was dialed by the user.
Trunks: 1~200
14-01-21 Caller ID Block Code
Enter the code, up to eight digits, that should be used as the Caller ID Block Code. This code is
automatically inserted before dialed digits if Program 14-01-20 is set to '1'.
Trunks: 1~200
14-01-22 Basic Trunk Data Setup - Caller ID to Voice Mail
Enable (1) or disable (0) the system's ability to send the Caller ID digits to voice mail.
Trunks: 1~200
14-02-10 Analog Trunk Data Setup - Caller ID
Enable (1) or disable (0) a trunk's ability to receive Caller ID name/number information. If this
option is set to '1', the system will suppress ringing and lamping for trunk calls for the first ring in
order to receive the Caller ID information.
Trunks: 1~200
14-02-16 Analog Trunk Data Setup - Caller ID Type
Select the type of Caller ID signal from an analog trunk - FSK (0) or DTMF (1). By default, this
option is set to "0" (FSK).
Trunks: 1~200
15-02-08 Multiline Telephone Basic Data Setup - Automatic Handsfree
Use this option to set whether pressing a key access a One-Touch Key (1) or if it pre-selects the
key (0).
15-03-09 Single Line Telephone Basic Data Setup - Caller ID Function-For External Module
Enable (1) or disable (0) the Caller ID FSK signal for an external Caller ID module or a 3rd party
vendor telephone with Caller ID display. If voice mail is used, this setting must be disabled or the
system integration codes for disconnect will be incorrect. For Caller ID Sender Queuing, set this
option to "1".
15-03-10 Single Line Telephone Basic Data Setup - Caller ID Name
Determine if a SLT extension user's telephone should display the Caller ID name (0 = Disable, 1
= Enable).
15-03-11 Single Line Telephone Basic Data Setup - Caller ID Type
Select the type of Caller ID signal sent from an SLT extension port - FSK (0) or DTMF (1). By
default, this option is set to "0" (FSK).
Caller ID
∗
67 (defined in Program 14-01-21) before the user dialed digits (this
Document Revision 1
2 - 151