NEC Electra Elite IPK II Features And Specifications Manual page 962

Document Revision 1
Programming - Using the Electra Elite IPK II DHCP
10-13-01 In-DHCP Server Setup - DHCP Server Mode
Enable (1) the system's ability to use the built-in DHCP server. The system must be reset in
order for the change to take effect.
10-13-02 In-DHCP Server Setup - Lease Time
Enter the lease time of the IP address to a client (default: 0 days, 0 hours, 30 minutes). The
system must be reset in order for the change to take effect.
10-13-04 In-DHCP Server Setup - Number of Networks
Select the number of networks in use on the system (default: 0, entries: 0=Single Network,
1=Divide Same Network). The system must be reset in order for the change to take effect.
10-14-01 Managed Network Setup - Scope 1
Set the range of IP addresses available to be used by the DHCP server for Scope 1 (default:
Minimum = 172.16.0.100, Maximum = 172.16.5.254, Scopes 1~10).
10-15-01 Client Information Setup
Set the IP and MAC addresses for each client (up to 10) when the DHCP server needs to assign
a fixed IP address to clients.
10-16-01 Option Information Setup - Router
Set the router address for the DHCP server to the client.
10-16-02 Option Information Setup - DNS Server
If required, set the DNS server address for the DHCP server to the client.
10-16-05 Option Information Setup - MGC
Set the MGC IP address for the DHCP server to the client.
Programming, Electra Elite IPK II IP Multiline Terminal or Electra Elite IPK II Multiline Terminal
with IP Adapter - DHCP
Setting the IP Address on an Electra Elite IPK II IP or Electra Elite IPK II multiline terminal with IP
Adapter Using a DHCP Server
1. On the Electra Elite IPK II IP multiline terminal, enter the telephone's program mode by pressing
∗
Hold Conf #.
This enters the IP User Menu program mode to select the settings for the individual telephone.

2. Access Network settings and press 1 to enter the DHCP mode. If not flashing, press 2 to enable
the DHCP mode. Press the softkey OK.
The flashing item is the current selection.

3. The entries for items 2, 3 and 4 are automatically set by the DCHP server.
4. The MGC IP Address is automatically set by the DHCP Server.
5. Press 3 to enter the IP telephone's extension number.
2 - 940
Electra Elite IPK II
Voice Over Internet Protocol (VoIP)