NEC Electra Elite IPK II Features And Specifications Manual page 169

Electra Elite IPK II
The stored number, however, does not contain the trunk access code. Without this code, the system
may not be able to seize an outside line to complete the call.
With this feature, when an Electra Elite IPK II Wireless user receives an incoming trunk call, the trunk
access code defined in programming can be added to the Caller ID. This will allow the system to seize
an outside line and then dial the stored number.
This function is only applied to incoming analog trunks. It does not apply to incoming extension
J
calls.
Caller ID must be available for this feature to work.
J
Caller ID Edit Mode (Program 20-19-03) must be enabled.
J
The maximum number of Caller ID digit is 20. If the total number of digits (trunk access code
J
(Program 10-02-05) and Caller ID) is over 20, the remaining Caller ID digits are not dialed.
For example:
Trunk Access Code (Program 10-02-05): 123456#
Incoming Caller ID: 12345678901234567890 (20 digits)
Electra Elite IPK II Wireless Dials: 123456#
Caller ID Sender Queuing Added
The Electra Elite IPK II system can provide Caller ID (calling party number) to a single line telephone
which has a display.
The system can queue incoming calls to the single line telephone if the system Caller ID sender
resources are busy. Refer to Program 20-19-05 in the Electra Elite IPK II Programming Manual.
If the single line telephone user lifts their handset while an incoming call is waiting in queue, they will
hear silence (no dial tone) and can not dial out. When the single line telephone user goes back on hook,
the system immediately sends the queued call to the single line telephone without Caller ID.
Option Available for FSK or DTMF Type for Single LIne Telephone
An option (Program 15-03-11) is available for the Caller ID which allows you to select either FSK or
DTMF as the Caller ID type to be received by a single line telephone.
Option Available for FSK or DTMF Type from Analog Trunk
An option (Program 14-02-16) is available for the Caller ID which allows you to select the type of Caller
ID signal from an analog trunk - FSK or DTMF.
Caller ID
∗
(8 digits)
∗
123456789012
Document Revision 1
2 - 147