NEC Electra Elite IPK II Features And Specifications Manual page 198

Document Revision 1
21-01-17 System Options for Outgoing Calls - Restriction Digit in Outgoing Disable on Incoming
Line
With the Outgoing Disable on Incoming Line feature, determine the number of digits (0~9) to be
dialed before the call should be disconnected.
21-02-01 Trunk Group Routing for Extensions
Assign Program 14-06 routes to extensions. (Trunk Group Routes: 1~100)
21-15-01 Alternate Trunk Route for Extensions
Designate the trunk route accessed when a user dials the Alternate Trunk Route Access Code.
Refer to "Trunk Group Routing" to set up outbound routing. (Trunk Group Routes: 1~100)
24-02-07 System Options for Transfer - Trunk-to-Trunk Transfer Release Warning Tone
This timer will start when a trunk begins talking with another trunk (e.g., trunk-to-trunk transfer,
outgoing from trunk, Tandem Trunking) (0~64800 seconds). Assign the time before a Trunk-to-
Trunk call will be disconnected.
82-08-01 Sidetone Volume Setup
Use this program to adjust of the multiline terminal side tone volume. There are two levels,
based on whether the connected trunk is a digital trunk or analog trunk.
Operation
To place a call over a trunk group:
1. Go off-hook.
2. Dial 704.
3. Dial trunk group number (001~100).
4. Dial the number.
- OR -
1. At the multiline terminal, press the trunk group key (Program 15-07-01 or SC 751:
2. Dial the number.
To place a call using Trunk Group Routing:
1. Go off-hook.
2. Dial 9.
If your system has an Alternate Trunk Route Access code, you may dial that instead.

2 - 176
Electra Elite IPK II
0 2 + group).
,
Central Office Calls, Placing