NEC Electra Elite IPK II Features And Specifications Manual page 640

Document Revision 1
Automatic Night Service
The system will allow or deny Automatic Night Service. If allowed, the calls will then route according to
the service patterns programmed. The Night Service programming is stored in the RAM memory. This
means that if the system is not using the Automatic Night Service, in the case of a power failure while in
night mode, when the power is restored, the system will continue to be in night mode.
Programmable Function Key Can Toggle Night Modes
The software allows a Night Service Programmable Function Key (PGM 15-07-01 or SC 751: 09 + 0) to
toggle night modes. You can determine in programming (12-08-01) how many modes through which the
user will toggle. Note that the additional data for the Programmable Function Key must be set to "0" for
the toggle function to work.
Conditions
r Almost all features are affected by Night Mode except for the following:
Dial Tone Detection
J
External Alarm Sensors
J
Flexible System Numbering
J
Pulse to Tone conversion
J
SMDR
J
Volume Control
J
r Call Arrival (CAR) Keys and Virtual Extension keys do not support Day/Night Mode (09)
Programmable Function keys.
r Universal Night Answer will only work when Call is sent to a ring group.
r There are separate Access Map and Ring Group programming entries for each Night
Service mode (modes 1~8). Also, "Universal Answer" allows an extension user to pick up a
Universal Night Answer (UNA) call.
r Mode Keys can be assigned as required for DSS Consoles.
With Universal Night Answer, outside calls can ring External Paging Zones.
r
r Programmable Function Keys simplify activating Night Service.
r The relay circuits (5~8) are on the PGD(2)-U10 ADP are programmed and used for General
Purpose Relays.
Default Setting
System is always in the Mode 1
2 - 618
Electra Elite IPK II
Night Service