NEC Electra Elite IPK II Features And Specifications Manual page 90

Document Revision 1
Related Features
Speed Dial - System/Group/Station
Central Office Calls, Placing
Dial Tone Detection
E-911 Compatibility
Code Restriction
Trunk Group Routing
Trunk Queuing/Camp On
Programming
11-01-01 System Numbering
Set the system's internal (Intercom) numbering plan. The numbering plan assigns the first and
second digits dialed and affects the digits an extension user must dial to access other
extensions and features, such as service codes and trunk codes. If the default numbering plan
does not meet the site requirements, use this program to tailor the system numbering to the site.
11-09-01 Trunk Access Code
Specify the single digit code used to access ARS (normally 9).
14-05-01 Trunk Groups
Program trunks of the same carrier type into the same trunk group.
14-07-01 Trunk Access Map Setup
Set up the Trunk Access Maps. This sets the access options for trunks.
Trunk Access Maps: 1~200
15-06-01 Trunk Access Map for Extensions
Assign Trunk Access Maps to extensions.
Trunk Access Maps: 1~200
20-03-04 System Options for Single Line Telephones - Dial Sending Start Time for SLT or ARS
When ARS or an analog extension user accesses a trunk and dials an outside call, the system
waits this interval before outdialing the first digit (0~64800 seconds).
2 - 68
Electra Elite IPK II
Automatic Route Selection