NEC Electra Elite IPK II Features And Specifications Manual page 813

Electra Elite IPK II
35-02-16 SMDR Output Options - Print Trunk Name or Received Dialed Number
Determine how the SMDR should print incoming calls on ANI/DNIS or DID trunks. If set to (1),
ANI/DNIS trunks can print DNIS digits. For DID trunks, if the received number is not defined in
Program 22-11-01, then no number will be printed. If set to (0) trunk names are printed instead
(as assigned in Program 14-01-01).
35-02-17 SMDR Output Options - Print Account Code or Caller ID Name
Determine whether the Account Code (0) or Caller ID name (1) should appear in the SMDR
record. By default, the Account Code will be displayed.
Program 35-01-08 must be set to "0" for this entry to be followed.

35-02-18 SMDR Output Options - Caller ID Name Output Method
Select whether to display up to 16 characters of the Caller ID Name on the same line as the call
record (0) or if a line feed should be added and up to 24 characters of the Caller ID Name will be
displayed on the following line (1). If the line feed option is selected, the Caller ID Name will be
displayed on the next line as : NEXT "Caller ID Name". The default entry for this option is "0".
This setting will work regardless of the setting in Program 35-02-15.
With this option set to "1", if your communications program (such as HyperTerminal) has the line wrap

option enabled in the ASCII setup, an additional line break may appear above the Caller ID name line.
35-03-01 SMDR Port Assignment for Trunk Group
Assign the SMDR port for each trunk group. For each Trunk Group, select the SMDR port to
which the incoming SMDR information should be sent.
Trunk Groups: 1~100
SMDR Ports: 1~8
35-04-01 SMDR Port Assignment for Department Groups
Assign the SMDR port for each Department Group. For each Department Group, select the
SMDR port to which the outgoing SMDR information should be sent.
Department Groups: 1~64
SMDR Ports: 1~8
80-05-01 Date Format for SMDR and System Reports
Set the date format for SMDR.
0 = American
1 = Japanese
2 = European
Operation
Once installed and programmed, SMDR operation is automatic.
Station Message Detail Recording
Document Revision 1
2 - 791