ABB Relion 670 Series Applications Manual page 296

Section 12
Multipurpose protection
=
t
op
æ
ç
è
EQUATION1372 V1 EN-US
where:
t
op
k
I
NS
I
r
By defining parameter x equal to maximum continuous negative sequence rating of the
generator in accordance with the following formula
=
x 7%
EQUATION1373 V1 EN-US
Equation
time of the negative sequence inverse overcurrent IED:
=
t
op
æ
ç
è
EQUATION1374 V1 EN-US
In order to achieve such protection functionality with one CVGAPC functions the following
must be done:
1. Connect three-phase generator currents to one CVGAPC instance (for example, GF01)
2. Set parameter
3. Set base current value to the rated generator current in primary amperes
4. Enable one overcurrent step (for example, OC1)
5. Select parameter
= ×
t k
op
EQUATION1375 V1 EN-US
where:
op
t
k
M
A, B, C and P are user settable coefficients which determine the curve used for Inverse Time Overcurrent
When the equation
the OC1 it is obvious that if the following rules are followed:
290
k
2
ö
I
NS
÷
I
ø
r
is the operating time in seconds of the negative sequence overcurrent IED
is the generator capability constant in seconds
is the measured negative sequence current
is the generator rated current
=
0, 07 pu
165 can be re-written in the following way without changing the value for the operate
1
×
k
2
x
2
ö
I
NS
÷
×
x I
ø
r
CurrentInput to value NegSeq
CurveType_OC1 to value Programmable
æ A ö
+
B
ç ÷
-
P
è M C ø
is the operating time in seconds of the Inverse Time Overcurrent TOC/IDMT algorithm
is time multiplier (parameter setting)
is ratio between measured current magnitude and set pickup current level
TOC/IDMT calculation
165 is compared with the equation
© Copyright 2017 Hitachi Power Grids. All rights reserved
1MRK 511 401-UEN Rev. K
167 for the inverse time characteristic of
(Equation 165)
(Equation 166)
(Equation 167)
(Equation 168)
Bay control REC670
Application manual