ABB Relion 670 Series Applications Manual page 69

1MRK 511 401-UEN Rev. K
IEC05000461 V2 EN-US
Figure 9:
In this example, one IED includes both transformer and line protections and the line protection
uses the same CT as the transformer protection does. For both current input channels, the CT
direction is set with the transformer as reference object. This means that the direction
Forward for the line protection is towards the transformer. To look towards the line, the
direction of the directional functions of the line protection must be set to
direction
case.
When a function is set to
noted that some directional functions are not symmetrical regarding the reach in forward and
reverse direction. It is in first hand the reach of the directional criteria that can differ. Normally
it is not any limitation but it is advisable to have it in mind and check if it is acceptable for the
application in question.
If the IED has sufficient number of analog current inputs, an alternative solution is shown in
Figure 10. The same currents are fed to two separate groups of inputs and the line and
transformer protection functions are configured to the different inputs. The CT direction for
the current channels to the line protection is set with the line as reference object and the
directional functions of the line protection shall be set to
Bay control REC670
Application manual
Transformer
Setting of current input:
Set parameter
CTStarPoint with
Transformer as
reference object.
Correct setting is
"ToObject"
Example how to set CTStarPoint parameters in the IED
Forward / Reverse is related to the reference object that is the transformer in this
Reverse and shall protect an object in reverse direction, it shall be
© Copyright 2017 Hitachi Power Grids. All rights reserved
Transformer and
Line protection
IED
Setting of current input:
Set parameter
CTStarPoint with
Transformer as
reference object.
Correct setting is
"ToObject"
Line
Forward
Definition of direction
for directional
line functions
Reverse . The
Forward to protect the line.
Section 4
Analog inputs
Reverse
63