Table of Contents
Advertisement
Use the same procedure to install from the installation media that contain the C Language
Library (option 032, 033, or 034).
When you install the HP 4062UX/F system software into a cluster
Note
environment, the HP-UX update procedure automatically checks to see if the
system is clustered. If the update procedure nds the system is on an HP-UX
cluster, update creates the necessary Context Dependent Files (CDFs) and
directories for all cnodes.
4. Change the
msgtql
If your controller is a series 300 computer, skip this step.
If your system is con gured in a diskless cluster environment, you must perform this step
for each diskless cnode and server.
The only kernel parameter for which the default value is not sucient is
recommended value for
parameter setup procedure, see
To change the
msgtql
1. Login as a superuser and execute the command: sam.
2. Open the
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
[Kernel Configuration ->]
3. Open the
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
[Configuration Parameters ->]
listed in alphabetical order.
4. Select and highlight
5. Select
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
[Actions]
6. Change the default value(40) to recommended value(256) in the box provided. Your
change is con rmed in the
7. Select
NNNNNNNNNNNNNNNNNNNNNNNNNN
[Action]
8. Select
NNNNNNNNNNNNNNNNN
[Yes]
9. Wait for the kernel build to complete.
If you need to change other parameters, change parameter values.
10. Select
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
[Exit Without Moving the Kernel Into Place]
11. Select
.
NNNNNNNNNNNNNN
[OK]
12. Exit sam.
13. As soon as you exit from
cp /etc/conf/dfile.SAM /etc/conf/dfile
5. Edit the
/usr/pil/etc/hwconfig.cf
con guration.
If your controller is a series 300 computer, skip this step.
5-8 Software Installation
parameter value in the d le by using SAM(1M) utility.
is 256. For details of each kernel parameter value and
msgtql
Installing and Maintaining HP BASIC/UX
parameter value, use the following procedures:
parameter column.
msgtql
, then select
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
[Modify Configurable Parameter]
Pending Value
, then select
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
[Create a New Kernel]
to the con rmation question.
, execute as follows:
sam
menu.
submenu. The kernel parameters are
column after you select
.
le appropriate for your HP-IB interface
. The
msgtql
.
.
.
NNNNNNNNNNNNNN
[OK]
.
Advertisement
Table of Contents
