Testing Each System Instrument; Cleaning - HP 4062UX Installation Manual

Testing Each System Instrument

This test checks the following items:
Self-test result of HP 4084B Switching Matrix Controller(s)
Self-test result of HP 4142B Modular DC Source/Monitor
Self-test result of HP 4280A 1 MHz C Meter/C-V Plotter, if it exists.
Self-test result of HP 4284A Precision LCR Meter, if exists.
Self-test results of HP 8110A 150 MHz Pulse Generator(s) (HP 4062F only).
Use the following procedure to check the test items above:
1. Set the LINE ON/OFF or POWER ON/OFF switch of each instrument, located on the
front panel of each instrument, to ON, and inspect each instrument for any errors or
failures.
After the inspection, leave the LINE ON/OFF or POWER ON/OFF switch of
Note
each instrument to ON to warm up the system instruments.

Cleaning

To prevent electrical shock, never use a wet cloth when cleaning the HP 4062UX/F. Always
use a slightly damp or dry cloth to clean HP 4062UX/F.
4-46 System Installation