Table of Contents
Advertisement
1 1 1 1 1 1 1 1
TERM=hp
if [ -x /usr/bin/tset ]
then
eval 'tset -s -Q -h'
if [ "$TERM" = "" -o "$TERM...
then
TERM=hp
ask="yes"
else
ask="no"
echo "TERM value from /e...
1 1 1 1 1 1 1 1
In the default settings, the HP-UX asks you to set the display type when you log in as a
root user. To suppress this question, change the parameter
and remove the sharp sign (
le
/etc/ttytype
To set your console display type, modify the /etc/ttytype le as follows:
98550a console
2397 tty00
2397 tty01
2397 tty02
The default setting of your console is
correct it. The display board inserted in the backplane of your computer shows the display
type.
For HP Visual User Environment (VUE) con guration, you can start the HP VUE screen
after booting the HP-UX system. To do so, the run level of the \init" procedure in the
/etc/inittab le must be set to 4 as follows:
init:4:initdefault:
stty::sysinit:stty 9600 clocal icanon echo opost onlcr ien...
brc1::bootwait:/etc/bcheckrc </dev/console >/dev/console 2...
. . . . . . . . . . . . . .
# change to...
) in the rst column as shown above.
#
(
for example
. If your display type is not
300h
(
change from \yes" to \no"
(
remove the \#" in the rst column
to
in the
yes
no
300h
=
(
Software Installation 5-5
le
/.profile
, you must
Advertisement
Table of Contents
