Installation Preparation; Contents Of Rack Mount Kit For The Hp 8110A - HP 4062UX Installation Manual

Table 4-9. Contents of Rack Mount Kit for the HP 8110A
Item
(1) Flange kit
2
(2) Flathead screw
(3) Insert washer
(4) Cup washer
(5) Power cable
(6) BNC T-adapter (m-f-f)
(7) Probe tip-to-BNC Adapter
(8) Resistive probe (10:1)
(9) BNC(f)-to-SMA(m) cable assembly
(10) 50 SMA terminator
(11) Pulse Adder/Splitter
(12) BNC(f)-to-BNC(m) cable assembly, 200 mm, yellow
(13) BNC(f)-to-BNC(m) cable assembly, 1150 mm, yellow 04062-61604
(14) BNC(f)-to-BNC(m) cable assembly, 1450 mm, blue
(15) BNC(f)-to-BNC(m) cable assembly, 200 mm, blue
(16) BNC(f)-to-BNC(m) cable assembly, 1150 mm, blue
(17) BNC(f)-to-BNC(m) cable assembly, 1450 mm, yellow 04062-61609
Quantity depends on total number of option 555 speci ed.
1
A ange kit contains two anges and four athead screws.
2
The 8120-1378 is for 100/120 Vac line voltage and the 8120-1763 is for 220/240 Vac line voltage.
3
Quantity depends on total number of HP 8110As to install in HP 4062F.
4

Installation Preparation

To prepare the HP 8110A for installation in the HP 4062F cabinet, refer to Figure 4-9 and
perform the following procedure:
1. Remove the side strips from each side of the HP 8110A.
2. Attach the rack anges to each side of the HP 8110A using the screws. The anges and
screws are contained in the ange kit (1).
3. Remove the 4 feet and 2 tilt stands from the bottom panel of the HP 8110A.
4-20 System Installation
Description Model/HP Quantity
Part No.
5062-3974 1 to 5
2680-0119 4, 8, 12, 16, or 20
3050-0248 4, 8, 12, 16, or 20
3050-0007 4, 8, 12, 16, or 20
8120-1378 or 1 to 5
8120-1763
3
1250-2486
10218A
10020-67703
04062-61606
1250-2151
15104A 0, 1, 3, or 5
04062-61603 0 or 1
0, 2, or 3
04062-61605 0 or 1
04062-61607 0 or 1
04062-61608 0, 2, 3, or 4
0 or 1
1
1
1
1
1
1
4
4
4
4
4
4
4