Table of Contents
Advertisement
Installing and Customizing Your System
This section gives step-by-step instructions for installing and customizing HP BASIC/UX, HP
4062UX/F software.
1. Install HP BASIC/UX.
To install HP BASIC/UX software, see
section provides only brief instructions and explanations.
If your HP-UX system is con gured into a diskless cluster, make sure to establish a diskless
cluster node (cnode) before installing the HP BASIC/UX system software. Note that you
must install the HP BASIC/UX system software in the cluster server.
Before installing HP BASIC/UX, go to
Note
BASIC/UX
released HP BASIC/UX.
To start the UPDATE(1M) utility and load the HP BASIC/UX les from DAT or cartridge
tape, use the following procedures:
1. Log in as a superuser by entering
Login: root
After the
Password:
password that you type is not displayed on your console.
2. To start the UPDATE(1M) utility, enter:
# update
After starting the UPDATE utility, follow the displayed instructions.
2. Install HP SICL 3.01 (HP 4062UX C Library for Series 700 Only)
If you use HP 4062UX C library (option 034) in series 700 computers, Hewlett-Packard
recommends to install
superuser. At least, install the following
PIL RUN
PIL PRG
PIL HPIB
For details of HP SICL installation, see
3. Install HP 4062UX/F software.
The HP 4062UX/F requires HP BASIC/UX, which must be installed on the HP-UX system
before the HP 4062UX/F software can be installed.
If the HP 4062UX/F is con gured in a diskless cluster, make sure to establish a diskless
cluster node (cnode) before installing the HP 4062UX/F system software.
The HP 4062UX/F system software is stored in cartridge tapes or digital audio tape (DAT)
cassettes. Table 5-3 shows the le sets of the system software.
5-6 Software Installation
Installing and Maintaining HP BASIC/UX
, which contains some important information for the currently
after the
root
prompt appears, enter the root password of your system. The
lesets of HP SICL 3.01 by using
all
three
Installing and Maintaining HP BASIC/UX
Read Me Before Installing HP
prompt as follows:
Login:
update
lesets that are used in HP BASIC/UX 7.01:
. This
command as a
.
Advertisement
Table of Contents
