HP 4062UX Installation Manual page 155

3. Select the
softkey. The HF port con guration page similar to Figure 6-45 appears.
NNNNNNNNNNNNNN
NEXT
Con rm that this information is correct.
d
Read the above message, then press "NEXT" to continue.
aaaaaaaaaaaaaaa
c
4. Select the
softkey. The start-up page of the 4062F AC test appears.
NNNNNNNNNNNNNN
NEXT
d
Select the desired softkey.
aaaaaaaaaaaaaaa
c
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
HP 4062F Performance Verification Program for AC function
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
*** HF PORT CONFIGURATION ***
HF1 PG11 HF2 PG12 HF3 PG21
HF4 PG22 HF5 HF6
HF7 HF8 HF9
HF10 HF11 HF12
aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa
NEXT
Figure 6-45. HF Port Configuration Page
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
HP 4062F Performance Verification Program for AC function
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa
START
Figure 6-46. 4062F AC Test Startup Menu Page
1. Do not connect the PG to Switch
input, CTRL of Cable Adapter or to
AUX2/3/4 of SWM.
2. Do not connect one PG to multiple
HF ports using T-adapter, but
connect to one HF only.
3. If you want to connect a PG to
another HF port, edit the FLCONFIG,
then run the PV4062 again.
User 1 Caps
aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa
User 1 Caps
aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa
HP-IB
ADDRESS
a
Running
b
a
Running
aaaaaaaaaaaaaaa
EXIT
b
System Verification 6-43