Table of Contents
Advertisement
6.
Relay Test
Install the HP 16075F Relay Test Adapter and relay test shorting adapter (HP part
number 04085-60006) on the SWM, then select the
immediately.
If a faulty relay is detected, the Relay Test stops and an error message like the one below
is displayed:
PV. ERROR !! A relay is open (contacts will not MAKE).
Relay#K21 on pin board#26.
Normally open contacts of a SENSE TRANSFER relay not functioning
properly.
While testing the HP 4085F SWM, the Relay Test performs a Pin Board Test, which
checks on/o (make/break) operation of all relays on the pin boards. If the Relay Test
nishes without errors, the test results are displayed as shown in Figure 6-13.
d
++++++++ RELAY TEST +++++++++
|RELAY TEST|OK
RELAY TEST FINISHED
SMU Test is next. Mount the 16346B atop the SWM and then select NEXT.
aaaaaaaaaaaaaaa
c
7. Remove the relay test shorting adapter from the SWM, then install the cable adapter.
|
aaaaaaaaaaaaaaa
aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa
NEXT
SKIP
Figure 6-34. Relay Test Results Page
softkey. The Relay Test starts
NNNNNNNNNNNNNNNNNNNN
NEXT
|---TEST RESULTS--|
| RELAY
|OK
| SMU
|
| VS
|
| VM
|
| AFU
|
| CMS C-G |
| CMS BIAS |
| DC LEAK |
User 1
Caps
Running
aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa aaaaaaaaaaaaaaa
System Verification 6-33
a
|
|
|
|
|
|
|
|
EXIT
b
Advertisement
Table of Contents
