Installing the HP 4284A
To install the HP 4284A into the HP 4062 system cabinet, refer to Figure 4-8 and perform the
following procedure:
1. Slide the HP 4284A into the system cabinet.
2. Secure the left rack
ange of the HP 4284A to the system cabinet using the furnished
washers (4) and (5) and screw (3).
3. Secure the right rack
ange of the HP 4284A to the system cabinet using the furnished tie
mounts (6) and screw (3), and install the cable ties through the tie mounts.
4. Connect the HP 4284A to the PDU with the power cable.
HP 4284A CMU84 Settings
When the HP 4284A CMU84 is installed in the HP 4062 at the factory, the HP 4284A comes
with Option 001 (power amplier) and Option 006 (2 m and 4 m cable length operation) and
the label \OPTION 001" and \OPTION 006" is attached to the rear panel. If the HP 4284A
is not equipped with Option 001 and 006, contact the nearest HP Sales Oce.
4-18 System Installation
Figure 4-8. Installing the HP 4284A