Table of Contents
Advertisement
Installing and Customizing HP IMA
Installing HP IMA/UX
To install HP IMA/UX system software from the distribution tape, perform the following
procedure:
1. Log in as a superuser by entering
Login: root
After the
Password:
password that you type is not displayed on your console.
2. Change to single user mode (run level s) as follows:
# shutdown 0
After about 30 seconds, the HP-UX system changes to single user mode.
3. Execute the
update
# /etc/update
4. The Main menu is displayed. The default source for the update is /dev/update.src. This
procedure assumes that /dev/update.src is set correctly. If the /dev/update.src setting is
not correct, refer to the
5. Make sure the distribution tape is set to write-protected state.
6. Insert the distribution tape into the tape drive and wait until the BUSY indicator turns o .
7. To load all les of the tape, select the
in the main menu.
All the les are loaded from the distribution tape.
8. After nishing the
with the following command:
# view /tmp/update.log
9. Remove the distribution tape and put it in a safe place.
When you install HP IMA/UX software into a diskless cluster environment,
Note
the HP-UX update procedure automatically checks to see if the system is
clustered. If the update procedure nds the system is on an HP-UX cluster,
update
for all cnodes.
Customizing for HP IMA/UX
To use the HP IMA/UX system properly, certain system les must be modi ed. For more
information about system les, refer to the HP-UX and HP BASIC/UX manuals.
/usr/lib/rmbrc or $HOME/.rmbrc.
5-14 Software Installation
root
prompt appears, enter the root password of your system. The
utility as follows:
HP-UX System Administration Tasks
Select All Filesets on the Source Media
utility, review the update log for any error or warning messages
update
creates the necessary Context Dependent Files (CDFs) and directories
Add the following lines to the con guration le:
after the
prompt as follows:
Login:
manual.
function
Advertisement
Table of Contents
